
Chapter#4 How to Use
4.4.5 Motion Detection
When you click Motion Detection on the Advance mode menu, the Motion Detection setting
menu appears. There are three Motion Detection functions which act as sensors and can be set
for different detecting zones. Each one has Threshold and Sensitivity inputs which you can
adjust to specific zone sequentially. Motion Detection function can support triggering FTP, SMTP
and Alarm output for capturing and sending images or starting alarm output.
Click On when you use the Motion Detection function and detecting zone appears for adjusting
and moving. The common setting options are displayed below. If you do not wish to use the
Motion Detection function, click it Off and press OK.
Motion Detection 1:Click On to use Motion Detection 1 function as a sensor. You can adjust
and move the detecting zone by using mouse.
Motion Detection 2:Click On to use Motion Detection 2 function as a sensor. You can adjust
and move the detecting zone by using mouse.
Motion Detection 3:Click On to use Motion Detection 3 function as a sensor. You can adjust
and move the detecting zone by using mouse.
Threshold:You can use the tool bar to set up-limit value. When detecting zone signals are over
setting value, it would carry on assigned work.
Sensitivity:You can use the tool bar to set down-limit value. When detecting zone signals are
over setting value, it would carry on assigned work.
Carry out the following steps:
1. Click On to use Motion Detection 1 choose one of eight orders.
2. A detecting zone 1 appears and use mouse to adjust and move the zone boundaries and
position.
3. Use tool bar to set Threshold and Sensitivity value.
4. Follow the steps to set the other Motion Detection.
5. Click the OK to save the setting.
Komentáře k této Příručce