CTC Union FMUX-01A Specifikace Strana 67

  • Stažení
  • Přidat do mých příruček
  • Tisk
  • Strana
    / 104
  • Tabulka s obsahem
  • ŘEŠENÍ PROBLÉMŮ
  • KNIHY
  • Hodnocené. / 5. Na základě hodnocení zákazníků
Zobrazit stránku 66
Chapter 5 Operation
67
5.6.4 Trunk Ethernet Parameter Config
The Trunk Ethernet Parameters Config screen will show the LAN1, LAN2 and SNMP management (M)
ports for both local (Lo) and remote (Re) multiplexers.
Each port can set an identifier reference "name", set the service mode, enable or disable auto-negotiation,
configure speed and duplex in forced mode (auto disabled) and enable or disable Ethernet flow control.
System Name: Trunk Ethernet Parameters Config
[F3]Site: All
+-----------------------------------------------------------------------------+
|[F1]St#/Pt# Serv Auto-Nego Duplex-Type Speed Flow-Ctrl Circuit Id |
|LAN/Lo/1 IS ON Full 100M OFF |
|LAN/Lo/2 IS ON Full 100M OFF |
|LAN/Lo/M IS ON Full 100M OFF |
|LAN/Re/1 IS ON Full 100M OFF #|
|LAN/Re/2 IS ON Full 100M OFF #|
|LAN/Re/M IS ON Full 100M OFF #|
| #|
| #|
| #|
| #|
| #|
| #|
| #|
+-----------------------------------------------------------------------------+
+-----------------------------------------------------------------------------+
| Edit[F2] Group IS[F5] Group OOS[F6] Back[ESC] |
+-----------------------------------------------------------------------------+
System Name: Trunk Ethernet Parameters Slot Editing
Location : Local/Port 1
[F1] Circuit Identifier : __________________
[F3] Service Mode : IS
[F4] Auto-Negotiation : ON
[F5] Duplex Type : Full
[F6] Ethernet Speed : 100M
[F7] Flow Control : OFF
+-----------------------------------------------------------------------+
| Confirm[F2] Back[ESC] |
+-----------------------------------------------------------------------+
Zobrazit stránku 66
1 2 ... 62 63 64 65 66 67 68 69 70 71 72 ... 103 104

Komentáře k této Příručce

Žádné komentáře